Hi,
question about “Configuration Applied” field in MWO (ServiceEngApp).
Where is it stored, when does it get evaluated, and when does it get re-evaluated?
I have run a lot of tests and am observing that it gets evaluated when a request task is first synchronized onto the device. But i cannot get it to consistently re-evaluate e.g. when a new, higher-weighted configuration is synchronized to the device.
Should this re-evaluation be achievable?
Workflow configuration is evaluated when a new task download to mobile. Also it does when new task is created in mobile. Additionally it is reevaluate when a filter attribute on task is updated. e.g Object Id.
Also it will re-evaluate when a change in existing workflow or a new workflow sync to mobile.
Thank you
From my testing last week it appeared that the last part was not behaving as you describe i.e. if i created a preferred workflow after syncing the task, the task was not reevaluating to that new workflow.
I was testing in 22r1 though so perhaps this has been corrected later.
I’ll try to test again in a later version to verify
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.