Hi,
I am trying to create a new layout for the report ‘Inventory Location No Barcode’. I am only changing positions and font size.
Original Report
Centered the Barcode and Location No
Report with the new layout. The barcode doesn’t appear.
Do you have any tips on how to overcome this.
Thanks & regards
Chaminda
Best answer by Manoj Ruwanhewa
Hi
Can you make sure that the container for the barcode is adequate in size and there are no over placements due to lack of space. You may need to increase the size of the container and make it more wider
These are manual adjustments depending on your placements.
I found a similar issue in community which might give you some additional tips.
Regards
Manoj
+15Hi
Can you clear the report cache and restart the application before verify again.
Regards
Manoj
Hi Manoj,
Thank you for the suggestion. I tried refreshing the report cache and restarting the application but it didn’t fix the issue.
BR
Chaminda
Hi
Can you clear the report cache and restart the application before verify again.
Regards
Manoj
+15Hi
Can you make sure that the container for the barcode is adequate in size and there are no over placements due to lack of space. You may need to increase the size of the container and make it more wider
These are manual adjustments depending on your placements.
I found a similar issue in community which might give you some additional tips.
Regards
Manoj
Hi Manoj,
Thanks a lot. It works now. The problem was that I had moved the barcode too much to the right so it didn’t have enough width. I moved it a bit to the left and then it works.
BR
Chaminda
+15Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
