In IFS 10 Aurena, we’ve just kicked off our QC dept and what we found is that entering analysis results is very tedious because we have to enter one line at a time instead of it being a table view that we can enter in each variable at the same time. Is there an overview screen to look at the inspection results for an Analysis Result for a shop order in Aurena Cloud? Basically, is this screen or interface any better in cloud than it is in Aurena 10?
Best answer by matt.watters
In my Apps10 Aurena I get this:
I have four data points on an analysis. Select data point 1 and enter/view results. Enter results, complete the data point, select next to move to data point 2 and repeat. Then close the dialog leaving 1 & 2 Completed and 3 & 4 Uncompleted.
Select data point 4 and enter/view results. The dialog opens at data point 4, cycling through data points 1 and 2 is not required.
+25Here, your Analysis Result page shows all the data points (1-9) for your operation 10. Selecting any one of these data points and then selecting Enter and View Results will take you to a dialog where you will enter the results for data point 1 then select Next to enter the results for data point 2 and so on. There is no overview table to enter values for all the data points such as in IEE.
Here I have two data points (1 and 4) connected to operation 10. I select one as stated above and enter the results for both data points in the same dialog using the Next command.
I can then see the results for all the data points in the Analysis Results - Variables/Attribute/Categorical depending on the type of data point.
I actually found an overview screen to see the Analysis Results - Attributes and Variables but edit isn’t allowed here. Maybe I should propose that we have edit capabilities on this screen because what’s happening is every time we go to enter results, it takes us through the ones that we’ve already completed which wastes time. If I click on the one line to view and edit results, it doesn’t give me the “next” option to let me put in more than just this one variable. It’d at least be nice if our users could choose at which point of the list of analysis results do they want to start entering results but it seems like they have to either go through all of them or do one at a time. Thank you for clarifying that this isn’t in cloud. This might be something that they can update or at least make it more user friendly.
+25In my Apps10 Aurena I get this:
I have four data points on an analysis. Select data point 1 and enter/view results. Enter results, complete the data point, select next to move to data point 2 and repeat. Then close the dialog leaving 1 & 2 Completed and 3 & 4 Uncompleted.
Select data point 4 and enter/view results. The dialog opens at data point 4, cycling through data points 1 and 2 is not required.
+9Hello,
I'd like to ask a question because I'm on AURENA and my customer would like to be able to enter analysis results in table mode, not line by line, by doing next. I don't see this as standard, not even on Cloud version 22 r1.2.
Do you agree with me? It's really long to enter an analysis when there are 30 lines, I think.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
