Receive Into Arrival, Perform Putaway

Hi Mitchell Moss,

Please check if you have setup basic data in following windows,

Basic Data

• Warehouse Navigator
  • Putaway Control for warehouse
  • Capacities and capabilities
• Storage Zones
• Putaway Zone Basic Data
• Inventory Part -->
  • Putaway Zones --> Inventory Values and Operative Values
  • Storage Requirement --> Capability Requirement

Thank you,
Dhananjani Palliyaguru

Hi @mmoss 

It's quite challenging to provide a response without examining your data. Typically, this error message suggests there's a specific issue with your data that's causing the putaway logic to struggle in identifying a location.

Please ensure that the warehouse you're receiving items in has NOT been designated as a Putaway Destination.

To pinpoint the exact problem, consider beginning with basic putaway zone settings, perhaps starting with just one storage zone.

regards,

Piyal

Recreated errors with parts 1-PR-PT, 1-PR-PT2 and 1-PR-PT3 in R&D’s Apps10 REGIONAL TEST LKP. Case owner from IFS Support will log this to R&D.

Hi @Roy Almeida, 

   I accepted this support case and will have closer look about the issue.

regards,

Piyal

Thanks @Piyal Perera 

Hi ​@mmoss,
I hope this issue is resolved now. However, responding to this will be helpful for someone in the future.

Make sure the inventory location (picking location) that you define in the warehouse navigator attached to the storage zone you defined.  Refer the screen shots and make sure these basic data are setup. 

Regards,

Dulani. 

​@DUWELK I am able to perform “Refill All Putway Zones” so the configuration is complete. I am not able to execute “Receive Into Arrival, Perform Putaway” for the same part number. What is the outcome of the support ticket?

Hi ​@mmoss, 

   Several months ago I investigated this issue and had discussions with our consulting team. I explained the problem is related to data setup. After a few days I closed the issue since no more questions raised. Do you still have the issue?

regards,

Piyal