Part Number not populating in Manage Fault Information

Hi Aravindi.

In order to be able to report a fault, you must have a serial that has at least Operational Status = Out of Operation and Operational Condition = Not Operational.

Geir Sigve

Hi @geirsigve ,

Thank you for the details. I am wondering how to set those statuses, as they cannot be edited through serial initialization.

Thank you 😊

Hi again.

If you query for your serial in Manage Serial Structure, you can use the functions Set Structure In Operation, Set Structure Out of Operation or Set Structure Operational.  I believe these are self-explanatory :-)

Geir Sigve

Hello @Aravinda.Pr 

Please review the setup of the data for the mentioned part, in the following screens. 

1. Part Master ( Serial Tracking Enabled, Manufacturer and Manufacturer Part Info updated )
2. Serial Part ( Life Limit, Manufacturer / Manufacturer Part info, Operational Parameters, Maintenance Group setup ) is completed

Subsequently the other details, Functions , Fault Functions etc need to be updated, as per the need for each part.

It’s only after these that the Serial Initialization into VIM / MRO is done.  VIM ( Vehicle information management) is setup intensive. Have only shared the key screens which are prequisites from a part level.  The setup defers/expands into more content, as per the solution needed - CRO ( Components Repair) , CAMRO (Complex assembly MRO) or AFMRO ( Airframe / Ships etc ) 

Regards

VIBHIN

@geirsigve @VivekBhandiwad @Thilini Kumarasinghe 

Thank you very much for dedicating your valuable time to resolving this issue. I am pleased to inform you that my issue is now sorted.

Best Regards,

Aravinda