Best answer by Lasanthi Jinadasa
View original
Employee card number without starting character
Userlevel 3
+7
How to setup employee card number without starting character in the system (Employee card parameters window)
Following need to be done in the Employee card parameter configuration.
For an example – Card number 603322
From 0th character (which is 6) length of 6 characters will be assigned as card number; which is 603322.
6 0 3 3 2 2
[0] [1] [2] [3] [4] [5]
Since the employee card number should be taken from the 0th position we can defined the card data which is derived from 0 – 5 and not 1-6.
Then enter the card number in the employee file, General tab, Card No field as 603322.
With this system will read the card as expected.
For an example – Card number 603322
From 0th character (which is 6) length of 6 characters will be assigned as card number; which is 603322.
6 0 3 3 2 2
[0] [1] [2] [3] [4] [5]
Since the employee card number should be taken from the 0th position we can defined the card data which is derived from 0 – 5 and not 1-6.
Then enter the card number in the employee file, General tab, Card No field as 603322.
With this system will read the card as expected.
Any thoughts? Do you think this should be raised as a case with Support?
Hi Kevin, Yes. Here we focused on Card Driven Execution. Therefore, it is better if you raise a support case for further investigation.
Reply
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.