Skip to main content

 

How to configure the LDAPS connection in IFS10?

When I connect to AD via port 389 (ldap) this is no problem, but when I connect via LDAPS 636 it shows the message:

Failed to connect to LDAP service: simple bind failed: ldap server: 636.

Seems to be a problem with SSL authentication. Help :) 

Hi,

What is your current update version? If you are below update 5, please request the patches from the solution 266373. 

 

Thanks,

Kasun

Hi,

What is your current update version? If you are below update 5, please request the patches from the solution 266373. 

 

Thanks,

Kasun

I have IFS 10 upd 7

Hi,

"Simple bind failed" error can happen due to few reasons such as:


1. because SSL is not working.
2. because the password entered is wrong.
3. because the port is not open.

please try to verify the above. 

Hi,

"Simple bind failed" error can happen due to few reasons such as:


1. because SSL is not working.
2. because the password entered is wrong.
3. because the port is not open.

please try to verify the above. 

  1. working ADFS authentication on Enterprise so SSL is working - 
  2.  LDAP working when using 389 port so password is ok
  3.  port is open - verify from powershell 

 

Hi,

"Simple bind failed" error can happen due to few reasons such as:


1. because SSL is not working.
2. because the password entered is wrong.
3. because the port is not open.

please try to verify the above. 

  1. working ADFS authentication on Enterprise so SSL is working - 
  2.  LDAP working when using 389 port so password is ok
  3.  port is open - verify from powershell 

 

If all the above checks out I can’t think of anything other than to check the domain resolution. Try switching to the domain name if IP is used. If this does not work let’s wait for the community to come up with an answer.. :) 

 

Reply


Terms & ConditionsCookie settings