Previously, the object connections in the document revision page showed both the object ID in the key field and the object description. Can both of these information be displayed here?
Solved
Document Object Connection - Equipment
+6Best answer by Amila Samarasinghe
Hi
As
BR,
+15Hi
Good question, after introduction teh Object Sequence as the unique code for the equipment this is not shown anymore. It should be possible to retriev this via a custom field, but then that is only valid in case the connection is on Equipment (so it will not show any data in case the object connection is to another LU. Previously the primairy key was CONTRACT and MCH_CODE.
Maybe someone else is coming with a better idea, but so far I can see is that only the Sequence and the description are shown.
Further, creating an idea here at the community could solve your question. I think it is a valid question, so hopefully it can be managed in core!
Good luck,
Robert
+6Hi Jami,
In what environment is this showing?
Regards,
Thilina.
+6Hi Jami,
In what environment is this showing?
Regards,
Thilina.
A build place
IFS Aurena framework version: 22.2.2.20221102174602.0
IFS Aurena client version: 22.2.2.20221102174602.0
IFS OData provider version: 22.2.2.20221103033800.0
+6Hi Jami,
After selecting the Object LU field, when selecting the object key field you can see the details including the object description. After selecting the object key and saving, the object description field will automatically be filled. I think there is no issue that both of this information be displayed.
+14Hi
As
BR,
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.