Hi,
Is it possible to change the default work order type in MWO for new work orders. Currently it defaults to work request, but we would like to change it to Fault report
Mark
Page 1 / 1
hi
Based in my knowledge, the status will get Fault report in case the field ‘Fault Report Flag’ is ‘1’ (TRUE).
Maybe you can make this field available in MWO and set it default to ‘1’. Then I guess it will set the status to Fault Report.
Maybe there also a setting for this, that I am not aware of.
Good luck.
Reply
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.