+3Hi All,
During shop order creation it cannot be saved because of this error message.(Scrap factor is mandatory).
But In product structure the Scrap factor is set to zero(0). It also in Inventory part u der manufacturing TAB Scrap factor set to (0).
May be this zero value (0) can not be fetched from BOM/Inventory part.
what could be the possible solution?
Best answer by dameenda
Do you see a value for the Scrap Factor in the Inventory Part/ Planning Data tab for the Shop Order Part?
+11Hi Jahid,
Remove default structure revision and alternate value and then try to save, though, the system would create Shop Order without Material line.
You can update desired Product Structure Revision and Alternate after creation of Shop Order.
Additional to above suggestion, please try with entering 0 in Scrap Factor (%) as well before saving the record.
+3Hi
As per your instruction i have tried but it cannot be proceed to save.
But in TEST environment its okay for all part no.
Even i have created another alternate and pick from LOV. but same error message showing
+11Hi
Have you tried to save after entering 0 in Scrap Factor (%) as I highlighted in screen shot?
+11then check with technical why default 0 value is not getting passed for Scrap Factor (%) with Shop Order creation.
Do you see a value for the Scrap Factor in the Inventory Part/ Planning Data tab for the Shop Order Part?
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
