We use the shop floor workbench to manage priorities at a work center. As soon as a partial qty is reported complete on an operation, it appears as executable at the next operation.
Work cannot begin on the next op until the previous op is fully reported. Is there any functionality in App 10 to make the subsequent op executable only when the previous op is fully reported complete?
Thanks!
Best answer by Björn Hultgren
Unfortunately there’s no possibility to configure the calculation of the executable quantity in this way. Maybe a custom field can be added showing the operation status of the previous operation, or a custom even triggering an error when starting an operation if the previous operation is not yet fully reported?
+23Unfortunately there’s no possibility to configure the calculation of the executable quantity in this way. Maybe a custom field can be added showing the operation status of the previous operation, or a custom even triggering an error when starting an operation if the previous operation is not yet fully reported?
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
