All,
When using condition based PM Action, is there a way to reduce the forecast calculation that is auto started when a measurement is entered? It’s currently looking like it goes out 2 years, or over 1000 lines and this is impacting the saving of the measurement.
Any suggestions on how to improve this are very much appreciated as we just starting to use this part of the software
IFS Cloud 24R2
Thanks in advance, Sarah
Best answer by Nethmini Kosvinna
Hi
You can change the object property below to 'BATCH' if it is currently set to 'ONLINE'. This will reduce the time it takes to save measurements, and the calculation of maintenance plans will occur in the background.
Thanks,
Nethmini
+21Hi
Please check the value you have for object property PM_PLAN_HORIZON ?
Best Regards,
Thilini
+18Hi
You can change the object property below to 'BATCH' if it is currently set to 'ONLINE'. This will reduce the time it takes to save measurements, and the calculation of maintenance plans will occur in the background.
Thanks,
Nethmini
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
