Hi,
We are on IFS APPS 10 UPD 14 and have scheduled a Quick Report (with a distribution list) using the Application Server Task as below. As you can see this task goes into ‘Finished’ status after few days or next day.
Task Schedule
I have seen few posts on this Community where the Application Server Task Status changes to ‘Finished’ but did not see a concrete answer to this. Appreciate if there’s any insight to this issue as I have to regularly setup this quick report now.
Many thanks
AJ
Dear
I’ve the same issue. Do you have a solution?
Hi
have you found any solution for this? We are experiencing the same issues right now.
Best regards!
I have the same issue, even though I have only created four tasks. Three of them are scheduled to run once a week, and the remaining one runs once every night. In a single queue, there are only two tasks.
The task that runs every day usually works for 1-7 days before entering the 'Finished' or 'Fail' state. Even though each time I create and test the task, it works fine, I still have to rebuild it every few days. I haven’t been able to find any explanation in the community for why this functionality is so unstable.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.