We have done the setup Automate Purchase Requisitions and Orders including Intersite, where site A raises workorder and from there PR / PO goes to SITE B. There is a part X available in both the sites , on site A it is a purchase part and in site B the same part X will be as manufactured part. Ideally the flow will start from Site A raising Purchase requisitions and then using order processing the pr gets converted to PO and then a customer order is getting created at site B , but the problem is we have to manually release those customer orders in order for shop orders to get generated. Is there a missing setup . I want these customer orders to be released automatically.
Page 1 / 1
Hi Arif,
You can set this field to ‘automatically’ in the site screen for the site B then the customer orders created from incoming messages will automatically assume the Released status.
that setup is also there in place , dont know why it is not getting released automatically.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.