Hi all,
I have encountered an error message stating, 'The reported by value cannot be empty,' when attempting to click the 'Finish' button for a New Request in Service Management. I'm wondering what might be causing this issue. Could you please advise on what steps I should take to resolve or mitigate this error? Thank you.
Best answer by Thilini Kumarasinghe
Hi Aravinda,
Please try below steps and check whether it works.
First take the service organization that you are using in the request and check the site and the company connected to it.
Then create a person ID and connect it to your logged in user.
Enter the person as an employee in the respective company.
Now try to create the request again and check whether the issue is solved.
Best Regards,
Thilini
+18Hi
Please check whether the logged in user has a Person ID connected. If not please create a Person record for the logged in user and check if that solves the issue.
Thanks,
Nethmini
+21Hi Aravinda,
Please try below steps and check whether it works.
First take the service organization that you are using in the request and check the site and the company connected to it.
Then create a person ID and connect it to your logged in user.
Enter the person as an employee in the respective company.
Now try to create the request again and check whether the issue is solved.
Best Regards,
Thilini
Thank you
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
