Hi Anthony,

No, a warehouse can only have one location defined.  This is information I found in the Warehouse.pdf documentation:

Normally, you should not be modifying the address for the warehouse once it was setup.

Checking QAC, the screen is the same and these buttons are also disabled.

Think about it this way… how would you select the address to ship products to the warehouse if there were multiple addresses allowed?

Hi Anthony,

I also checked with R&D about the buttons.  The situation is the page for managing addresses against the warehouse is the same page used for other documents.  Thus depending on where you open this page, the buttons are enabled or disabled.  As R&D also confirmed there can only a single address for a warehouse, these buttons are disabled in the warehouse module - address page.  However, you can update or change the warehouse address if needed.

Hope this answers all your questions.