Hi Björn,

I do not think this is possible without a code change. You only have one contact on the service order which I believe is used to pre-populate or from the primary contact of the site.

If you were to do this, where or how would you determine which addresses to use for pre-population? Let’s say there were 5 contacts linked, you may want to only send to two of them not all five for example.

HI Bjørn,

You asked a similar question three years ago and it was not possible without customisation. This was confirmed by Jacques Cormier that he had to write a BRD to supply to R&D if they would like to add to standard.  

Unfortunately, this did not make it into standard so it would have to be done as a customisation if you want this type of functionality.

Hi all

reading the question, just a note. In 15.4 there is a new functionality when sending Report from Mobile, it has a + sign and when clicked that shows all Site based contacts - to be selected and then will be added to the list of emails to send to.

Regards, Bart

Thank you, Bart.

I was responding to auto-populating but this would work to select quickly instead of auto-population.

Kind regards,

Phil