+6Inventory parts With out Input UoM Group
Shop order no: 204708
Shop floor work bench
Select issue material Manually
When proceed to finish Error message pop up : Input unit of measure cannot be used when the issued quantity is split into serials
Is there any option I need to select. To avoid this Error: Input unit of measure cannot be used when the issued quantity is split into serials.
Best answer by dameenda
Hi Sicanandan;
I tried in BNT as I mentioned above and worked well there, then i checked the version in Regional Test and realized it has the version that the patch we fixed in the same area is included.
Thats why I mentioned “If recreates in the Regional Test” as the patch MFZ-19839 is included in 23.2.4 which is the SU applied in the Regional Test.
Then Patch MFZ-19839 must have fixed the issue.
Hi Sivanandan;
If this recreates in the regional test, then this is a BUG to be fixed.
Please report to RnD.
Hi Sivanandan;
Please check if this option works without any error.
Same flow without opening the Operation Guide
+6Hi @dameenda,
Before submitting my report to R&D, I retested the issue and didn't encounter the error.
I observed that the core environment has been updated to 23R2 SU4 (23.2.4), This might be the reason for the change.
I recall that when I initially encountered this issue, it was in version 23R2, not in this specific version, 23.2.4.
Can you please advise.
Hi Sicanandan;
I tried in BNT as I mentioned above and worked well there, then i checked the version in Regional Test and realized it has the version that the patch we fixed in the same area is included.
Thats why I mentioned “If recreates in the Regional Test” as the patch MFZ-19839 is included in 23.2.4 which is the SU applied in the Regional Test.
Then Patch MFZ-19839 must have fixed the issue.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
