Hello,
I am looking for a way to enable the “receive into inventory on last operation” by part number. I see that there is a way that you can do it by work center, but I can’t find anywhere to do it by part number. If anyone knows of a way to do this, I would greatly appreciate it!
Thank you,
Matt
+23It can only be set by work center.
Maybe you can add a separate “Receive” operation after the last normal operation?
That may cause more confusion than it is worth. We would then have to have an operator take count on that step every time which could be overlooked. I think we are going to do training for the operators to manually click the “Receive” check box at the bottom of the pop up when they take count on SFWB. Thanks!
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
