I created a custom page based on a projection in Aurena. I added it to the Navigator using Navigator Designer. The entry shows up in Navigator and when I click it the page shows the page title but without any content. If I go into Page Designer I see my page content. If I make a change, save, publish, revert change, save, publish, and exit Page Designer the content displays. I am on IFS 10 update 9. Is this a known issue or is there a workaround? This only applies to a custom pages and I don’t see this behavior with Standard pages.
Question
Aurena Custom Page browse from Navigator
+5This topic has been closed for comments
+5We applied update 10 to our development environment. Now when we restart the server the changes that were only visible in Page Designer and now visible on the standard page. Clearing the meta data cache using the steps over here:
sometimes works instead of having to do a full reboot.
+5Correction, we are on update 9 currently.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.