Skip to main content

Hi Community,

 

Created a Cust Order for 50 units. Order Release, Reserved and units Picked.

 

2x handling units created and I attach the parts and define each serials via the Attach Reservation screen. So my current shipment contains 2x HU and 25x units on each (the units are serialized).

 

But I would like to change it, to have 2 units (specific serial numbers) taken from the HU #736 and to move them to the HU #735.

How could I achieve that system movement without having to unattach all 25 units of HU# 736 and to re-attach it all again except the 2 units I want to change HU place.

 

Thanks.

 

How about try and link the un-attach and attach processes together and send part value between them.?

Could you please detailed a little your suggestion, in few steps. Because I do not get how to perform that.

 

 

Hi Guillem,

Let us assume in this case that you want to remove the 2 units from HU - 735 and move to HU 736.

On clicking on the reservation details under the HU - 735, for Shipment Line 2 - Part No 1223404L1 (screenshot attached), you will see the page with Edit option. There you can edit the Quantity (and Serials) attached to the HU - 735.

Saving this will make the Quantity (Serials) unattached and available to be reserved for HU - 736. You can do that by clicking on the HU - 736 and using the Unattached Shipment Lines Tab, where the two serials from the step before this are available to be attached.

Hope this helps.

Regards.

Hi Nikhil,

Thanks for your feedback. Tried it, diminishing the attached quantity by 2 and then I was able to attached using the Unattached Shipment Lines to the other handling unit, choosing the serials. So did work.

Reply


Terms & ConditionsCookie settings