Skip to main content

Hi All,

is it possible to activate the list of value for the “to location No” in the Data Collection Configuration “Process Part on Transport Task” to change this location? At the moment it´s not possible:

 

there is only the possibility to select the entered location

 

However, if I enter the location manually, it is accepted by the system.

 

 

Is it a BUG or an incorrect configuration?

Thank you for your help.

Regards 

Marina

Hi @IneMarinM 

Make sure the configuration is set as below

 

Hi @IneMarinM,

We may have to do a detail investigation to identify the root cause. So, I would suggest you to report this behavior through a support case.

 

Regards,

Harsha

Hi @IneMarinM 

Make sure the configuration is set as below

 

Suggested Configuration

 

Hi @Hashini Kodippili 

I have adjusted the configuration as above, but it still does not work. At which position is the to location no?

Regards

Marina

Hi @IneMarinM ,

If you query to the configuration ID 1 in “Process Part on Transport Task”  process you can find the standard input orders.
Hashini

@Hashini Kodippili ok then I use the standard input order and it doesn´t work. So I will create a support case.

@IneMarinM 

Does this issue is fixed? 

Reply


Terms & ConditionsCookie settings