Question

Unable to remove a part from Disposition shop order

  • 20 November 2019
  • 1 reply
  • 172 views

Badge +1

Initially A part  was included in work scope as a piece part and not as a module . Later, work scope was changed to include it a s a module. System is not able to remove DSO for A part even though we have not touched it . 


1 reply

Userlevel 2
Badge +7

Hi,

 

You can remove the DSO and include the part A as a module to work scope. Please follow below steps. I have done this in App10.

 

  1. Bring the DSO status to ‘Released’ or ‘Planned’.
  2. Exclude the part from work scope and release the work scope as well as Interim Order structure.
  3. Install the module / serial part in parent serial structure and include to work scope using ‘Complete Partial Offlog’ functionality.
  4. Calculate the maintenance level again in work scope.
  5. You will see the part A is appearing as a module, then set the maintenance level and release the work scope to proceed further.

Best Regards,

Thieuban Ampalavanar

Reply