+7
Hi!
Recently we uncovered that an user was adding new reading values for an object into Measurements for Object window, and all the readings inputed were not being recorded, as seen below:
Even using the Manage Preliminary Reading option I can’t make the Measurement Type change into Recorded Reading.
Does anyone had the same problem before or have any idea how to solve it?
Thank you!
Best answer by rcruz
View original
+7
I found out what the problem was. The meter flip value on Serial Object window was set as 2010h.
I set the correct flip value and the problem was solved.
Thanks, that was the case.
unfortunately, the so many generated WOs I cancelled it. and this impacted the future WOs as well. is there any way we could get them back >?
regenerating plans is not helping as the WO is cancelled manually from the WO screen.
thanks again :-)
+7
Thanks, that was the case.
unfortunately, the so many generated WOs I cancelled it. and this impacted the future WOs as well. is there any way we could get them back >?
regenerating plans is not helping as the WO is cancelled manually from the WO screen.
thanks again :-)
Hi
Hi there , sorry I posted this in the wrong place. please ignore
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.
