Engineering Part Revision used to have a checkbox that would set the part revision to Released on save.
I believe it was in a grouping called “On Save”. It is very handy when all you want to do is Release the revision and not fight the step of going to Active.
Did that get removed?
Patrick
Best answer by matt.watters
Document Revision had this, Engineering Part Revision never had it.
It is now an option in the Status command.
All that remains in the “On Save” area is Distribute.
+26Document Revision had this, Engineering Part Revision never had it.
It is now an option in the Status command.
All that remains in the “On Save” area is Distribute.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
