Community,
kindly advise what is the best way to batch upload parts into IFS? I was told there is a bug in IFS API, and some mandatory fields are missing in engineering part after migration.
Thank you.
Solved
Batch uploading Parts into IFS
Best answer by EriLNL
Hi
Actually the sequence can be reversed
- Import external structure
- for any parts not known yet, in that structure, use RMB “Create Engineering part”
- when all unknown are created, save the imported structure
Regards Erik
Hi Ron,
In most cases this is done with a migration job or with a specific interface.
There is a simple solution in the Engineering part revision, tab Consist Of, RMB “Import External Product Structure”, in combination with RMB “Create Engineering Part”.
That of course only works if you are using Engineering parts in IFS
Regards Erik
we are using engineering parts. the RMB function you mentioned in your reply, should do in sequence, if i am not wrong.
- Create Engineering Part
- Import External Structure
is that correct?
Thank you.
Hi
Actually the sequence can be reversed
- Import external structure
- for any parts not known yet, in that structure, use RMB “Create Engineering part”
- when all unknown are created, save the imported structure
Regards Erik
+21I prepared a threat that has migration jobs attached. See:
Reply
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.