All,
When Selecting the pre-posting command for site 198, I get the following message: Pre-Posting is not enabled for this source.
What am I doing wrong?
This command is working for other sites:
Thanks,
Solved
Pre-Posting command on Material Requisition Screen Not working for particular Site
Best answer by Abdul
Hi
M107 would enable Pre-posting at Material Requisition Line level, and M109 would need to be defined if you want to enable Pre-posting at Material Requisition header level.
I referred your screenshot, where you were unable to enter Pre-posting information at MR headers level and therefore suggested to define M109.
Regards
Abdul Rehman
+20Hi
Please check whether Posting Control M109 is defined for the company to which site 198 belongs.
Please refer to the screenshot below.
Regards
Abdul Rehman
We have posting control for site 198 set up under M107 currently. Are you suggesting that we recreate under the M109?
We had been using posting control M107 and have had it working in the past.
+20Hi
M107 would enable Pre-posting at Material Requisition Line level, and M109 would need to be defined if you want to enable Pre-posting at Material Requisition header level.
I referred your screenshot, where you were unable to enter Pre-posting information at MR headers level and therefore suggested to define M109.
Regards
Abdul Rehman
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.