Morning Heros,
I am a bit confuse. Accord to IFS sizing documentation for 25R1, for our configuration, we should have in general 2 replicas for each pod. I resize them and for some (like you can see below), I have 6 replicas and they are completely full. My users are noticing some slowness on navigation. What should I do? Any idea? Did anybody have this problem?
Thanks,
Gianni Neves
What are you showing? what are the columns?
Is it memory limit and memory request? They are always the same.
The currently used memory is shown with:
kubectl top pods
I would be surprised if 6 client-service pods shouldn’t be able to handle a massive amount of use load.
thanks
The columns are MEMORY USAGE, MEMORY RESQUESTS and MEMORY REQUESTS %.
The command kubectl top pods shows the same results. So, I don’t see any resource been freed after use and it stays always at maximum utilization. So, if I’ve used just 2 pods like recommended by IFS, my system would be massive slow.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
