We use the filter a lot on the Consists Of tab in the Engineering Part Navigator.  We look for, say, a specific Drawing Position and create a filter for that.  We then select different part numbers from our selector and we expected that the filter remains in place.  The system used to work this way.

We’re now on 23R1 and the filter is worse, now.  As you as you select a different part number, the filter that was set on the first part is removed and the filter section collapses.  So not only can’t you use the same filter while selecting different part numbs, but you also have to re-expand the filter section in order to re-enter the criteria.

I view this as a significant reduction in the useability of the UX.

Is there any way to put this back the way it was before 23R1?

Patrick