We had a power outage at our plant, after employees had ATTENEDED IN, but before they could report and production. we do not use SHOP FLOOR WORKBENCH, how can i go into the employees’ labor record and record production of parts and also scrap?
Question
shop floor reporting of part quantities
+9Hi
Based on your scenario and IFS standard behavior, you can still manually report labor, production, and scrap without using Shop Floor Workbench. The key point is that attendance (attended-in) is handled by HR/Time, while production and scrap are handled at the Shop Order / Operation level.
1️⃣Report production manually on the Shop Order
Navigate to:
Manufacturing → Shop Orders → Shop Order Reporting → Report Operations
2️⃣Report scrap (if any)
From the same Shop Order:
Shop Order Reporting → Report Scrap
3️⃣Report labor time separately (no Shop Floor Workbench)
Since you do NOT use Shop Floor Workbench, use one of these instead:
Shop Order → Report Labor Operations
Summary
| Item | Where to record |
| Attendance | HR Attendance (already done) |
| Production qty | Shop Order → Report Operations |
| Scrap | Shop Order → Report Scrap |
| Labor hours | Shop Order → Report Labor or HR Time |
| Shop Floor Workbench | ❌ Not required |
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.