25R1 version!
Issue Observed on work tasks:
- While assigning work, the Allocations / Direct Allocations section did not show the full list of resources.
- The “Apply Constraints” toggle was disabled to check if it affected visibility.
- Even after disabling it, resources from other resource groups were still not displayed.
Under Allocations Tab:
- In 24R1 Release: I was able to see all resources list under the allocations tab upon disabling the ‘Apply Constraints’ button.
- Whereas, in 25R1 version, even after disabling the toggle button, only the resources listed under the specific resource group/demand were displayed.
Under the Direct Allocations tab:
- The resource list is empty. Not even a single resource id was displayed.
- So, currently, i cannot assign any specific resources to the work tasks and unable to transfer them to MWO.
Has anyone else run into the same behavior or noticed similar missing resources?!--
- Any guidance or suggestions would be appreciated.