Hi,
When running Master schedule level 1 for some parts we get this errormessage:
ManufStructureUtil.INVSERVAL: Invalid serial boundary value(s) for structure selection. - must be numeric.
Have anybody seen this before and know what could cause the error?
We are on IFS 10 upd 3
/Anna
Hi,
This problem was corrected by R&D at the end of 2019 and added to IFS Applications update 8. The internal bug id is 151491. Right now I have some technical problem in locating the Case ID for this bug. But anyway, there is a fix for your reported problem in a later update.
Best Regards,
Mats at R&D
Hi,
Thanks for quick reply, have reported to support to get this fix.
Do you know if there is some workaround available?
We have MS setup to create so req’s for entier horizon, just tested to change it to create so req with planning time fench for 10 days defined but then I got the same errormessage.
When creating manually a shoporder req I do not get this errormessage.
/Anna
Hej Anna,
Well, I don’t know any workaround, actually the best shot would be to run MS Level 1 calculation ‘integrated’ with CRP. There is a checkbox. It will take longer time, but could be interesting to try out my theory.
-Mats
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.
