hi, community,
while receiving the goods I need to perform the inspection for the goods, however after choosing the receive case as receive into arrival ,inspection at arrival , location to receive, and no of qty to inspect there is an error “ goods cannot be moved to the specified location before being fully inspected”
Steps performed: I have checked the same in ref no in inspection management it is not reflected there.
Looking for your assistance,
thanks
Best answer by Jackie P
View originalHi
When you register the arrival they need to be received into an “Arrival” location. You then have to go to the “Receipt” screen and RMB and register inspection results if all the parts have past the inspection just press ok, the to be inspected quantity will then be zero. You should then be able to move the parts to a “picking” location.
Hope that helps.
Jackie
hi,
register inspection results is not highlighted.
Hi
Did you set the inspection on the SFPP or on the PO line?
Is there a quantity in the “to inspect box”? If not try entering a quantity to inspect in the box and then that should give you the option to register the inspection results.
Thanks
Jackie
hi
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.
