PR is not closed even after the PO is created.

Hi Everyone,

I am having a situation, can anyone tell me what can be the cause..

PR already converted to PO but still showing in authorized PRs. The PR is not closed even after the PO is created.

thanks in advance.

Page 1 / 1

@Hashmit are there perhaps any lines in No Part Requisition Lines that haven’t been converted to a PO?

Normally, once all the PR lines are converted to PO, the PR should move to Closed status.

@Hashmit What is the application version and is this PR originated from a WO ?

Application 10, UPD 7. PR is not originated from WO, but parts are mastered by eCatalog

If there are No lines in “No Part Requisition Lines” as well, or the lines are closed, the PR should be closed after the creation of the PO.

May be the status did not change due to a data synchronizing issue.

Sign up