Hello all.
Is there anyway to change the unit of measure setup for an inventory part record? Over the years when changes have happened to a part or simple data entry issues, this has come up and we have not found a good solution.
Thanks,
Rich
You can only change the Unit of Measure from the Master Part, and only then after removing the Inventory Parts. You can’t remove the inventory parts unless they haven’t been used in a transaction. If it has been used over years and now has a Unit of Measure change - it isn’t the same part - it is a new part number. That is the only solution.
Reply
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.