To simplify for Manufacturing operators using Shop Floor Work Bench, we are trying to set a default Work Center when the manufacturing user logs on and is taken to his homepage (Work Bench). We have tried setting a filter then saving the user profile but it did not work. Can this be done?
Thanks
Best answer by Björn Hultgren
If you run Workbench in "Anonymous Mode" you can set a default filter for the user in the Properties dialog (in Enterprise Explorer client) as you figured out!
If you run Workbench in "Employee Mode" a default filter is connected to the Shop Floor Employee or Team.
oops, I may have found figured it out. In Properties, I entered a default filter and saved the user profile.
+23If you run Workbench in "Anonymous Mode" you can set a default filter for the user in the Properties dialog (in Enterprise Explorer client) as you figured out!
If you run Workbench in "Employee Mode" a default filter is connected to the Shop Floor Employee or Team.
Thanks, Bjorn,
Since our users do not have access to ‘Properties’ to set the default, I had to grant them ‘everything’ permission (that includes Properties), log in as them, set the default in Properties, then remove the ‘everything’ permission from them. I could only log in as them since it was a new ID (otherwise, the manufacturing users would be logged in during all 3 shifts). Is there a better way to set the default for a user who does not have access to Properties/screen layout, etc?
Thanks
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
