Limit location to a single part

Hi @Anupa95 -  Are you referring to the Part number or a single quantity of the part? Im not 100% sure if its in Apps9, but theres an option on the Inventory Location called ‘Mix of Part Numbers Blocked’ which if set to yes would prevent different parts from being receipted into that location.

If its quantities, then you can investigate using Storage Requirements against your Locations/Parts. You can define Quantity per Locations when defining the Storage Volume Requirements against Inventory Parts. 

Thank you for your reply.

I was referring to a Part Number.

The option you mentioned is available in APP9. However, when the location is emptied, you can receive another part in the same location.

The requirement is that now allowing to receive a different part than what was previously received in that location.