Hi,
I want to add watermark on a report. Even after following steps as per documentation, it is not showing the water mark. Customer is in Apps10.
Any idea how can I fix it?
Also, is there a way of showing water mark based on a condition? My requirement is to show ‘COPY’ watermark when copy is printed. I want to hide water mark when original document is printed. Can this be achievable?
Appreciate your comments.
Thank you.
Best answer by shewa
I managed to fixed this issue. Image should be copied to path defined in System Parameters with the correct folder structure. I.e MODULE/REP
Example. Image should be copied to INVOICE/INSTANT_INVOICE_REP inside folder path defined in System Parameters.
+15Hi,
Check if the watermark image is copied to the image folder location pointed through the system parameter “Graphich path for Report designer...”. If it’s there make sure that it’s a valid jpg, png format and not a bmp.
You can’t add conditions to waters.
Regards,
Chanaka
Hi,
Check if the watermark image is copied to the image folder location pointed through the system parameter “Graphich path for Report designer...”. If it’s there make sure that it’s a valid jpg, png format and not a bmp.
You can’t add conditions to waters.
Regards,
Chanaka
Any suggestions?
Thank you.
I managed to fixed this issue. Image should be copied to path defined in System Parameters with the correct folder structure. I.e MODULE/REP
Example. Image should be copied to INVOICE/INSTANT_INVOICE_REP inside folder path defined in System Parameters.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
