Hi Experts,
Can you please share some reference documents on Disassembly Shop orders (Order Type) and Background to it.
Can it be used for Servicing the Csutomer Owned Products like Engine. MRO Solution is not part of the Scope so, we are planning to Disassemble and Repair it via Shop orders.
Appreciate your help.
Thanks !
Regards
Lokesh
Best answer by Björn Hultgren
The disassembly shop order functionality was released in IFS Cloud 23R1, and you will find useful material about it in the Release PowerPoint for 23R1 release.
In short it was developed primarily to support the remanufacturing process which includes the disassembly of a worn-out product (referred to as a Core). However, it can be used quite generically when a product needs to be disassembled into its components. Might be that you have manufactured a product, but the order is canceled so you want to returned the components back to stock, or if you disassemble products to sell the components as spare parts.
It is possible to also disassemble a customer owned part.
+24The disassembly shop order functionality was released in IFS Cloud 23R1, and you will find useful material about it in the Release PowerPoint for 23R1 release.
In short it was developed primarily to support the remanufacturing process which includes the disassembly of a worn-out product (referred to as a Core). However, it can be used quite generically when a product needs to be disassembled into its components. Might be that you have manufactured a product, but the order is canceled so you want to returned the components back to stock, or if you disassemble products to sell the components as spare parts.
It is possible to also disassemble a customer owned part.
+2Hi, can it handle slitting (martial) master rolls, to smaller widths?
Total width = (100*5) + (50*9) + Scrap (50) =1000
Thank you in advance
+24However I think you are better of by creating a shop order for say Item 1 with the Master roll as a material line and then receive Item two as a By-Product.
+2@Björn Hultgren Thank you for your time answering my question. Currently we do use the below process -
Feedback is only By Products not formula Item, Lot tracking.
We get discrepancies in allocation of material variance, labor and OH absorption.
Hoping this could give you a better insight about our current process and challenge.
Thank you again and looking forward to your reply.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
