We use the option to associate an outbound location to a work center. The work center is used for shop orders (both make to order and make to stock). For make to order shop orders it is not possible to receive finished goods from the work center to the outbound location unless the location is a picking warehouse type. It is not possible to receive mto shop order output in a floor stock location. Reason: in floor stock location one must not receive parts which are reserved.
However, we are reluctant to define the outbound location as a picking warehouse type because then the stock on this location could become a target for reservation jobs, manual reservation, or creation of pick list.
Has anyone an idea/solution for how to prevent the stock on an outbound location from reservation/creation of picklist (if the location is picking warehouse type) or alternatively how to enable the floor stock type outbound location to receive make to order parts?
Question
MTO shop orders to outbound locations
Reply
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.