Skip to main content

CLOUD 24R1

Scenario: 

Prerrequisites: Handling unit type with packaging material part associated and ‘Reusable’ option enabled.

  1. Go to the Inventory part in stock and select a part that has not handling unit connected. Select the option to Pack according to Handling unit Capacity and enter the quantity to pack for an specific Handling unit type. 
  2. The part is packed with an specific handling unit ID.
  3. The packaging material of the handling unit type is consumed automatically and issue from the stock
  4. If I go again to the Inventory part in stock and select the part that I have just packed and select ‘Unattach from handling unit’ for unpack, the system will not receive again the packaging part into stock to be able to be used again for another packing. The quantity on hand of the packaging material should not be increased?

Thank you in advance.

Hi,

After unattaching the parts, you need to navigate to Handling Unit page and run the “Receive Packaging Material to Inventory” command in order to restock the packaging material part.

 

Regards,
Upasari

Hi @Upasari thank you for your support.

I also realized that the system does not prevent to use a HU ID, that has been delivered previously  to the Customer. This is correct? I deliver a HU, with capacity for 2 pieces, to the customer. Then, I use the same HU ID to pack parts in my stock (2 pieces). When I create the customer return, the system receives the parts to the previous HU ID that is currently used by another parts and does not take into account the capacity of the HU. Is that correct? is there something that needs to be set up beforehand?

 

Thank you

Reply


Terms & ConditionsCookie settings