Initially A part was included in work scope as a piece part and not as a module . Later, work scope was changed to include it a s a module. System is not able to remove DSO for A part even though we have not touched it .
Page 1 / 1
Hi,
You can remove the DSO and include the part A as a module to work scope. Please follow below steps. I have done this in App10.
- Bring the DSO status to ‘Released’ or ‘Planned’.
- Exclude the part from work scope and release the work scope as well as Interim Order structure.
- Install the module / serial part in parent serial structure and include to work scope using ‘Complete Partial Offlog’ functionality.
- Calculate the maintenance level again in work scope.
- You will see the part A is appearing as a module, then set the maintenance level and release the work scope to proceed further.
Best Regards,
Thieuban Ampalavanar
Reply
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.