+6Below is a question raised by a customer.
If there is any way that when the inspection checkbox is removed from a part that this applies to all outstanding PO’s that were created when the check box was active?
Also can this be done in reverse whereby when the inspection checkbox is selected that it shows on PO’s for that po that have already been created?
Dear
I’m not quite sure to what checkbox you refer, but as per your question, a parameter related to inspection has been changed midway when orders have not been received.
If that is the case, the scenarios you mentioned are plausible in my opinion.
The best practice would be not to change basic data when there are pending orders to be received.
Anyway, you can reach the IFS Product development team or get official confirmation. Yet one way or another, i believe they might suggest sticking to the best practice I suggested as well.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
