How to exclude stock for some parts during MRP run .

Hi @Deepak ,

If I understood your requirement correctly you want to remove the stock availability from MRP process for certain parts. If so, you can use Availability Control ID functionality to fulfil your requirement. Part availability control is used for determining the availability when you make reservations or planning on inventory part locations. By using parameter Part Supply Control, you can Determines whether the parts are available and plannable. If set as Not Nettable then parts are not plannable or available in the availability check, order proposal, and MRP.

You can define availability control id in the window path - Warehouse Management/ Basic Data/ Inventory Basic Data/ Part Availability Control tab. You can use this availability control id in Inventory Part in Stock window to restrict the relevant parts from being using for MRP. To set the ID you can select the Record and RMB on it, Select Change Availability Control ID. This will get you a new dialog box to set the Availability Control ID.

Note: Setting Control Availability ID for an Inventory Location is a one-time setup. Once you
connect an availability control id for the location it will remain until you remove it from the
location.

Hope this will help.

Regards,

Akila

Hi @Deepak ,

You can set the safety stock of those parts to the qty that you are currently having. Then, then MRP will consider the safety stock of that value and generate purchase requisitions for the order demands.

Thank you and Best Regards

Thushitha