Available Orders for a shipment

Hi Bldrayi,

Please make sure that the following conditions are satisfied for the customer orders to appear

• The supply code for customer order lines must not be Purch Order Dir, Int Purch Dir, Not Decided or Service Order.
• The order line must be in the Released, Reserved, Picked or Partially Delivered status. Picked Customer Order Lines must be in a shipment location.
• There must be a remaining quantity that is still to be delivered for the customer order line i.e. what is already delivered and what is already connected for delivery on shipments must be less than the ordered quantity.
• There must not be any quantity not connected to any shipment on a pick list not pick reported yet.
• The order line must not be included on any customer load list.
• The order must not be about to be delivered with a pre-ship delivery note.
• There must not be any partially delivered order lines with a connected freight charge not invoiced.

Further, to connect to an existing shipment, the following prerequisites should be met.

• The shipment must be in the Preliminary status to connect the lines. Note: If required, you can reverse a shipment from the Complete status to the Preliminary status, but not from the Closed status to the Preliminary status.
• The shipment type, receiver, ship-via and delivery terms of the source line must be that same as the shipment.
• The delivery address of the source line must be the same as the shipment. It is not enough to have the same delivery address ID; all address information must be the same.

Hope this helps!