@Dario Zani I have done it the same way. But again I was able only to pick the first line, the second was deleted again somehow….Furthermore I had to start from the same starting position again (Enter Pick List No), instead of the second line. As mentionend, same pick list no is not available anymore as it deleted the second line automatically smoehow:Can maybe the RELEASE_RESERVATION cause the problem? I’ve defined Fixed Value = Yes and Use Automatic Value = Fixed but it should not as it can always be I can not fullfill each line on a Pick List so that we have a partial delivery?
@Dario Zani Hi Dario, can you forward me printscreens of your REPORT_PICKING_PART configuration you fixed so that if Last line on Pick List = No - the next line will be displayed automatically in the wadaco and you don’t have to start from the beginning & entering Pick List No again.
@Dario Zani I did not remove the original control feedback, it is at the same place as the original Config. No. 1 (Step 30 “Barcode”). Once in the process it recognizes it is not the last line (Last line on pick list =No) it will end the process and close the pick list…. I removed the PICK_LIST_NO in the General Tab but same result. Settings are same as in the configuration Report Pick Shop Order Pick List.
@Dario Zani It worked according to your suggestion. Now I wanted to do the same for the Wadaco Configuration “Report Picking of Parts for CO” but it failed. Did I miss som The result I get is, that the Pick List will be successfully picked & confirmed unfortunatly I will get back to the first step as I would start a new Session. Requirement is the same, that I can stay in the same Pick List and do not have to enter it again.
Hi DarioI tried it with the second option and created the Barcode with tabs for the Wadaco and Shop Floor Workbench.In some occasions it works fine in the Shop Floor Workbench, but in the most cases the following error message appears:often the case if more then one Release No available but not only then… Same behavior appears when you paste a copied order no in the Order No field.often the case if more then one Release No available but not only then… Same behavior appears when you paste a copied order no in the Order No field. And in the wadaco only the order no will be scanned:Do you knwo what I could change in the configuration as it is the exact sequence as required:
Yes Pick by Choise is allowed.I tired it now even with configuration id 1 - the IFS default and still received the error message: Setup of the Part:
I figgured out, that the message appears only if location is = WMS, could this be a reason behind it? Because for other locations it works fine.
Hi I changed it to the default value but same error message as before:
Already have an account? Login
No account yet? Create an account
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.
Sorry, we're still checking this file's contents to make sure it's safe to download. Please try again in a few minutes.
Sorry, our virus scanner detected that this file isn't safe to download.