Part dimensions

  • 30 September 2022
  • 2 replies

Badge +2

Hello, is there a way to store dimensions of a part in IFS i.e the length and width of a part?

2 replies

Userlevel 3
Badge +8
We can enter directly in the Inventory Part / Storage Requirement tab which is the value for the Specific Site (highlighted by a Red Square above)


Or we can define in the Part Level (Not Site specific) by attaching a Capacity Requirement Group in the Storage Requirement Tab as below (Black Square).

Then it will be applied to the part in all the Sites unless the value is overridden in a particular Site as above.





Badge +2

Thank you for your response! I was under the impression this tab was on how to store the part and not necessarily the part’s physical dimensions itself.  I’ll review and see how far I get.