Hi Experts,
I am trying to use the INPUT TYPE = ‘Inbound XML’ for the inbound maps in xml map as shown below.
It seems INPUT TYPE = ‘Inbound XML’ is not working but the INPUT TYPE = ‘Response XML’ is working as expected.
Why inbound xml type is not working here? Are there any additional configurations that I need to do?
Thanks,
Hasara
+22
Hi
Have you looked into the baseline xml maps with inbound maps? Could you change the execution point to After End and and try out the same? Plus most of the given inbound maps seems to have an accept condition when it comes to commits.
Hi
Thank you for the response.
yes, I have already checked the baseline xml maps with inbound maps and tried to use the same approach here also.
tested this by modifying execution points to before/after commit and after End.
Tested this by adding the accept condition also.
But still it is not working.
Thanks,
Hasara
+22
Hi
Perhaps it would be best to raise a support case if none of the solutions worked for you.
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.
