hi
Do you know why the total value is not incremented ? the parameter is accumulated ?
I added a new unit measure : numeric
Thanks
Regards
Best answer by EqeRobertK
View originalhi
Do you know why the total value is not incremented ? the parameter is accumulated ?
I added a new unit measure : numeric
Thanks
Regards
Best answer by EqeRobertK
View originalThanks a lot
Hi
The new reading you enter should be the total.
So the new value is equal or higher than the previous value (only incase of a roll over of the meter, or there is a new meter installed).
So in case you expect 2 stops, you need to enter 2 as the the new value.
If you need more information, you can use the online help text (F1).
Good luck,
Robert
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.