Hi all,
Frequently we have to make a tool used for manufacturing a part.
We create the tool in IFS and connect it to a routing.
But how do we handle that the tool must be manufactured before we can release the shop order for the part?
Hi all,
Frequently we have to make a tool used for manufacturing a part.
We create the tool in IFS and connect it to a routing.
But how do we handle that the tool must be manufactured before we can release the shop order for the part?
Hi,
In addition to that, a Tool/Equipment can be connected to a Manufacturing Tool Instance. The tool/equipment can be used for resource planning and as a maintenance object.
The tool/equipment needs to be connected to the site defined for the manufacturing tool. The manufacturing tool instance cannot be connected to more than one tool/equipment, but one tool/equipment can be connected to manufacturing tool instances on different sites. The tool/equipment needs to be connected to the same site as the manufacturing tool.
From the Resource Navigator window:
From the Manufacturing Tool window:
Hope this clarifies the issue at hand.
Regards,
Dasuni
Hello, you can link the manufacturing tool to a serial object (service and maintenance module in Apps9) where you can create a work order for it to be manufactured. However I am not sure if this will flag that it needs to be manufactured before the shop order will run, whoever this might be a good place to start and some custom events might be the best way to flag this to production
Thank you for the suggestions. We are looking into it.
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.